Offices in Bangalore, Chennai and Hyderabad
95919 46404 roopa@etechnologyconsultants.com
Etechnology Service ConsultantsMEP design consultancy Discuss a project

Turning ideas into reality

Nine MEP disciplines under one roof, designed together from the first schematic to good-for-construction drawings.

Office ceiling with a supply grille, ducts and a linear light
9 disciplines

One building, nine services

Every service runs through the same cores, ceilings and plant rooms. Designing them together means they fit before anything reaches site.

Pick a service to trace it from the plant room to every floor.

One building, nine services. Pick one to trace it from the plant room to every floor.

Inside the ceiling void

Every service competes for the same space above the ceiling. This is the order we fit them in.

Swipe the drawing sideways to see the whole section.

  1. Ducts first. They are the largest item, so they claim their zone before anything else.
  2. Cable trays go high. Power and data stay above any pipe that carries water.
  3. Chilled water next. Pipes get room for insulation, valves and hangers.
  4. Sprinklers thread through. Mains run between services, with a drop to every head.
  5. Drains keep their slope. A drain cannot rise, so its route is fixed early.
  6. The ceiling lines up. Lights, diffusers and sensors sit on one grid.
Structural slab Beam False ceiling Ceiling void Supply duct Cable tray Chilled water Sprinkler Drain, laid to slope Lights, diffusers and sensors on one grid

What you receive at each stage

The design is delivered in two stages, each with its own set of documents.

Stage 1: schematic design

A concept built from your inputs, industry standards, the budget and the look you want.

  • Design basis for every service
  • Load and demand calculations
  • Schematic layouts
  • Equipment and space requirements

Stage 2: detailed design

The concept worked up into documents you can build and tender from.

  • Good-for-construction drawings
  • Bills of quantities
  • Specifications
  • Equipment schedules

For designs and buildings that already exist

  • Power audit

    We measure where a running building uses power and where it can use less.

  • Design review

    We check another consultant's MEP design for gaps, clashes and over-sizing before it is built.

  • Third-party inspection

    We inspect installed systems against the design and flag what needs fixing before handover.

Design basis reportLoad calculationsSingle-line diagramsSchematic layoutsCoordinated drawingsBOQSpecificationsGFC drawingsTesting and commissioning support

Building types we design for

  • IT office spaces

    Dense seating, long shifts and layouts that keep changing.

  • Data centers

    Redundant power and precision cooling for uptime.

  • Commercial buildings

    An efficient central plant and tenant-ready risers.

  • Residential buildings

    Reliable water, power backup and low upkeep.

  • Villas

    Discreet services and comfort in every room.

  • Hospitals

    Clean air and power that never drops.

  • Schools and colleges

    Fresh air, good light and safe ways out.

  • Hotels

    Quiet comfort and hot water on demand.

  • Malls

    Large crowds, smoke control and tenant metering.

  • Museums

    Stable temperature, humidity and careful lighting.

  • Industries

    Heavy loads, utilities and process ventilation.

  • Infrastructure

    External power, water, drainage and street lighting.

Not sure which services you need?

Send us the drawings and we will tell you what the building needs.

Talk to a director Chat on WhatsApp